1. On the main screen press the green OK button to get to the Core Menu
   • If the green OK button does not work try...
     • On Aura non-touch models press F1 for Core
     • On Aura Touch Models tap the 3 lines at the bottom of the screen
    
2. Select Utility
3. Enter Password
4. Select Communications
5. Select Local Parms.
6. Select Ethernet 
7. Select Mode
8. Select DHCP or Static
9. Confirm that you would like to change connection types [f2] Yes or [f4] No
10. If you selected Static, See the instructions for setting Static IP Below
    If you selected DHCP Press the red Cancel button until you are back to the normal home screen

1. On the main screen press the green OK button to get to the Core Menu
   • If the green OK button does not work try...
     • On Aura non-touch models press F1 for Core
     • On Aura Touch Models tap the 3 lines at the bottom of the screen
    
2. Press 4 for Utility
3. Key in Manager Password 1234
4. Press 3 for Communications
5. Press 2 for Local Parms.
6. Select appropriate interface
   • Ethernet
   • WiFi (if supported)
7. Press 1 for Mode
8. Select appropriate Mode
   • DHCP - Will not be able to set static IP information
   • Static - Will be able to set static IP information
9. Confirm changes by selecting YES (F2) or cancel by selecting NO (F4)
10. Select Static Parms.
11. Select which Static Parms you wish to update
    • 1 for IP
    • 2 for Netmask
    • 3 for Gateway
    • 4 for DNS1
    • 5 forDNS2
12. After selecting an option, press the yellow Backspace button once to remove existing values.
13. Screen will show 000.000.000.000. Key in new IP address.
    • Each section must be 3 numbers
    • Dots added automatically
14. Press green OK button to confirm
15. Once complete, press red Cancel button until back on home screen
16. Power cycle terminal to ensure changes take effect. Ping test to verify connectivity.